 |
| SYS-1015B-M3B |
- SuperServer 1015B-M3B (Black)
|
| |
|
| CPU |
- Single LGA775 ZIF Socket
- Supports Quad-Core Intel® Xeon® X3300/X3200 series
- Supports Dual-Core Intel® Xeon® E3100/3000 series
- Supports Intel® Xeon® processor L3360 and L3110 series
- Supports Intel® Core™2 Quad Q9000/Q8000/Q6000 series
- Supports Intel® Core™2 Duo E8000/E7000/E6000/E4000 series
- Supports Intel® Pentium® E5000/E2000 series
- Supports Intel® Celeron® E1000 and 400 series
- NOTE: Intel Xeon processor L3014 requires an LGA771 socket and is not supported.
|
| System Bus |
- 1333 / 1066 / 800 MHz system bus
|
| |
|
| Memory Capacity |
- Four 240-pin DIMM sockets
- Supports up to 8 GB of memory (Dual Channel)
|
| Memory Type |
- DDR2 800/667MHz unbuffered ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs
|
| DIMM Sizes |
- 256 MB, 512 MB, 1 GB, 2GB, 4GB
|
| Memory Voltage |
|
| |
|
| Chipset |
- Intel 3210 chipset
- ICH9 +2x Intel® 82574L + LSI 1068E
|
| SAS |
- LSI SAS1068E
- RAID 0, 1, 10 support
- (Optional: AOC-IButton68) RAID 5 support
|
| Serial ATA |
- Intel® ICH9 SATA2 (3 Gbps) controller built-in
|
| IPMI |
- On board IPMI with dedicated LAN
- Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Winbond® WCPM450
|
| Network Controllers |
- 2x Single-port Gigabit PCI-Express Ethernet Controllers
- Intel® 82574L
- Supports 10BASE-T, 100BASE-T, 1000BASE-T, RJ45 output
|
| VGA |
- On-board Winbond® integrated Graphics
|
| Super I/O |
|
| Clock Generator |
|
| |
|
| SAS |
|
| Serial ATA |
- Two Serial ATA ports (3 Gbps performance)
- Two SATA hard drives supported
|
| Floppy |
- 1 Floppy controller; 1.44 MB
|
| LAN |
|
| USB |
- Up to 8x USB 2.0 / 1.1 compliant ports
- 2 rear ports
- 2 internal headers + 2 on-board
|
| VGA |
|
| Keyboard / Mouse |
- PS/2 keyboard and mouse ports
|
| Serial Ports |
- 1x Fast UART 16550 serial port
- 1x internal header
|
| |
|
| BIOS Type |
- 16Mb Flash EEPROM with Phoenix BIOS®
|
| BIOS Features |
- Plug and Play (PnP)
- DMI 2.3 support
- PCI 2.2
- ACPI 1.0/2.0
- SMBIOS 2.3
- USB Keyboard support
|
|
 |
|
|
| Form Factor |
|
| Model |
|
| |
|
| Height |
|
| Width |
|
| Depth |
|
| Gross Weight |
|
| Available Colors |
|
| |
|
| Buttons |
- Power On/Off button
- System Reset button
|
| LEDs |
- Power status LED
- HDD activity LED
- 2x Network activity LEDs
|
| |
|
| PCI-Express |
|
| |
|
| Hot-swap |
- 8x 2.5" Hot-swap SAS / SATA drive bays
|
| |
|
| 1x SAS / SATA Backplane |
| |
|
|
| Fans |
- 4x 40x28mm high-efficiency fans
- 6x fans maximum
|
| |
|
| 560W AC to DC power supply w/ PFC |
| AC Voltage |
- 100-240 V, 50-60 Hz, 6.5-2.6 Amp
|
| +5V |
|
| +5V standby |
|
| +12V |
|
| -12V |
|
| +3.3V |
|
| Certification |
80 PLUS Silver Certified
[ Test Report ] |
| |
|
| CPU |
- Monitors for CPU Cores ( +1.8V, +3.3V, +5, ±12V, +3.3V Standby, +5V Standby, VBAT, HT, Memory, Chipset)
- CPU Core 4-Phase-switching voltage regulator with auto-sense from 0.3750V-1.6000V
- Adjustable CPU clock frequency ratio
|
| FAN |
- Total of six 4-pin fan headers
- 6x fans with tachometer monitoring
- Status monitor with firmware / software speed control
- Status monitor for on/off control
- Support 3-pin fans (without speed control)
- Low noise fan speed control
- Pulse Width Modulated (PWM) fan connector
|
| Temperature |
- Monitoring for CPU and chassis environment
- CPU Thermal Trip support
- Thermal Monitor (TM2) Support
- PECI
|
| LED |
- CPU / System Overheat LED
- +5 Standby alert LED
|
| Other Features |
- Chassis intrusion detection
- Chassis intrusion header
|
| |
|
RoHS
|
|
| Environmental Spec. |
- Operating Temperature: 10°to 35°C (50°to 95°F)
- Non-operating Temperature: -40°to 70°C (-40°to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
|
Купить / Заказать / Узнать цену
